Aerosol

236

Energy & Fuels 2009, 23, 236–243

Mercury Emissions Control in Coal Combustion Systems Using Potassium Iodide: Bench-Scale and Pilot-Scale Studies

Ying Li, Michael Daukoru, Achariya Suriyawong, and Pratim Biswas*

Aerosol and Air Quality Research Laboratory, Department of Energy, EnVironmental and Chemical Engineering, Washington UniVersity in St. Louis, St. Louis, Missouri 63130 ReceiVed August 12, 2008. ReVised Manuscript ReceiVed October 23, 2008

Addition of halogens or halides has been reported to promote mercury removal in coal-fired power plants. In this study, bench- and pilot-scale experiments were conducted using potassium iodide (KI) for capture and removal of Hg in air and coal combustion exhaust. Two bench-scale reactor systems were used: (1) a packedbed reactor (PBR) packed with granular or powder KI and (2) an aerosol flow reactor (AFR) with injection of KI particles. It was found that a higher temperature, a higher concentration of KI, and a longer gas residence time resulted in a higher Hg removal efficiency. A 100% Hg removal was achieved in the PBR above 300 °C using 0.5 g of powder KI and in the AFR above 500 °C with a KI/Hg molar ratio of 600 at a 5.8 s residence time. The low KI injection ratio relative to Hg indicated that KI is highly effective for Hg removal in air. Formation of I2 vapor by the oxidation of KI by O2 at high temperatures, which then reacts with Hg to produce HgI2, was identified as the pathway for removal. The pilot-scale experiments were conducted in a 160 kW pulverized coal combustor. KI was introduced in two ways: as a powder mixed with coal and by spraying KI solution droplets into the flue gas. In both cases the Hg removal efficiency increased with an increase in the feed rate of KI. Mixing KI powder with coal was found to be more effective than spraying KI into the flue gas, very likely due to the higher temperature, longer residence time of KI, and the formation of a secondary reactive sorbent. The Hg removal by...