Abdullah Papur

Start Here

1

Important setup information

Wireless or wired network users: you must follow the instructions in this setup guide to be successful adding the HP All-in-One to your network. USB cable users: Do not connect the USB cable until step A2.

2

a

Remove all tape and lift display

b a Remove all tape and protective film from the lid and from the front, back, and both sides of the device. b Lift the color graphics display and remove the protective film. You can adjust the height of the display to a position suitable for viewing.

3

Locate components

HP Photosmart C6100 All-in-One series

Basics Guide

Windows CD Basics Guide

4 x 6 in (10 x 15 cm) photo paper

USB cable *

Mac CD adapter

control panel faceplate (may be pre-attached)

Ethernet cable * * May need to be purchased separately.

Documentation CD

This CD may be included for some languages where help is not available through the software.

power cord ink cartridges

The contents of your box may differ.

phone cord

HP Photosmart C6100 All-in-One series Setup Guide

4

a

Attach the control panel faceplate (if not attached)

b

a Position the control panel faceplate over the buttons on the device.

b Press down firmly on all edges of the faceplate until it snaps into place. Make sure all buttons come through the holes in the faceplate.

5

a

Load paper into bottom tray

b c d

Load plain white paper in the bottom paper tray. Plain paper is needed for alignment.

6

a

Load photo paper

b c

a Lift the output tray.

b Pull out the photo tray.

c Load the 4 x 6 inch (10 x 15 cm) photo paper from the sample pack with the glossy side down in the photo tray. Tip: If the paper is tabbed, make sure the tab is towards you.

d

e

d Lower output tray and push in the photo tray.

2 • HP All-in-One

e Pull out the tray extender and lift up the paper catch.

7

Connect the supplied phone cord

Connect one end of the supplied phone cord to the...