Share Proper Maintenance Measures Raymond Mill Equipment

　    Raymond mill equipment has been widely used in powder metallurgy production line within the industry , building materials, chemical, mining , etc., as this machine must do routine maintenance work .

　1 , as Raymond mill confidential parts often work so it should be better lubrication , only under the conditions of lubrication to prevent wear of the shaft , so as to delay the life of the machine , but do lubricated also can not add too much lubricant , but also appropriate to keep clean the shaft .

　2 , non- metal into the machine, due to the hardness of the metal is larger, it will wear the shaft inside the machine , or even cause damage to the central part.

　3 , feeding should be uniform, can not be erratic , feeding too much will lead the machine outlet , the impact of the machine running , charging too little will cause the machine Depletion , thus leading to the decline in production .

　http://www.rollersmill.com

　4 , the air volume can be adjusted appropriately according to the fineness , appropriate adjustments to production requirements , generally open to the maximum position , to be noted that the small amount of wind , precipitation material easily hosts below the duct , should be adjusted .

　5 , adjust the fineness of the material to be adjusted according to the size of the corresponding fineness, to achieve the best results, increase the fineness, production will be reduced accordingly, if it is below standard debugging fan speed , which can be flexibly adjusted .

　    6, Raymond mill stop , stop feeding , the residual abrasive continue milling about a minute later, the host of the motor can be turned off to stop grinding work , which then stops the fan motor to purge residual powder.

　    7, when the remaining wall thickness of the Raymond mill roll grinding ring is 10mm or less , indicating that Raymond powder machine roll grinding ring has reached the limit.