Which Brand of Ball Mill Is Used Well?

Different kinds of ball mill it inspection standard are all different, the cement mill inspection standard what? Below we focus on the once, cement mill inspection standard.1. Watts a spherical surface evenly have horns; Every 50 x7 was not less than 50 in 1, 2 point; Hollow shaft and tile interface should be 90 °, 100 ° every square inch of not less than 2 points, shaft neck and bearing clearance approximate the same on both sides.2. Cement mill when installation should be lining board first to be installed by cover, cylinder liner should start with population, according to the assembly requirements, the screws to even the tight, shall not be leaking. Rubber lining board with may not have crack, there are gaps in relation to sponge.3, ball mill barrel flange to the front cover of the surface should guarantee with good contacts, not add gaskets, two hollow shaft don"t allow the coaxial tolerance of less than 0.8 mm difference. Big tooth circle and the cylinder cover in connection assembly correction, should be strong thrust, superior location pins, the circle of radial run-out not more than 0.5 mm, axial runout not greater than 0.84 mm.Scientific management, advanced processing technology and innovative manufacturing theory make Hongixng become the exporting base of magnetic separator machine, concentrator table price and famous grinding equipment in China. What Hongxing has done is for the clients and we believe that quality is the best way to develop market.4, ball mill lining board when installation should be installed by first cover, cylinder liner should start with population, according to the assembly requirements, the screws to even the tight, shall not be leaking. Rubber lining board with may not have crack, there are gaps in relation to sponge.5, small gear with the centerline of the centerline big gear to parallel, the deviation is no more than 0.2 mm per meter. The tip clearance tooth 1/4 modulus, tooth side clearance 1.06-1.8 mm, ball mill tooth surface...