Submitted by: Submitted by MACHO0321
Views: 43
Words: 406
Pages: 2
Category: Other Topics
Date Submitted: 11/09/2014 09:01 PM
1. Routers have different types of memory. Choose the answer that describes flash memory. (Points : 10) |
provides working storage stores a fully functional IOS image stores the startup configuration file initializes the code used to boot the router |
Question 2.2. Routers have different types of memory. Choose the answer that describes NVRAM. (Points : 10) |
provides working storage stores a fully functional IOS image stores the startup configuration file initializes the code that is used to boot the router |
Question 3.3. Where does a router look for boot system statements? (Points : 10) |
ROM RAM NVRAM Flash |
Question 4.4. Which command will copy an IOS image from a TFTP server to a router? (Points : 10) |
Router# copy tftp flash Router# copy flash tftp Router(config)# copy tftp flash Router(config)# copy flash tftp |
Question 5.5. If a router cannot find a valid configuration file during the startup sequence, what will occur? (Points : 10) |
The startup sequence will reset. The router will enter setup mode. The startup sequence will halt until a valid configuration file is acquired. The router will generate a default configuration file based on the last valid configuration. The router will monitor local traffic to determine routing protocol configuration requirements. |
Question 6.6. Which command turns on a router interface? (Points : 10) |
Router(config-if)# enable Router(config-if)# no down Router(config-if)# s0 active Router(config-if)# interface up Router(config-if)# no shutdown |
Question 7.7. What is the default state of the interfaces on a router? (Points : 10) |
up, line protocol down down, line protocol down administratively down, line protocol down up, line protocol up |
Question 8.8. . If a router is unable to find a valid...