How to Operate Desander and Desilter ?

Desander is solid control system two solids control equipment for the separation of the drilling fluid is greater than 47 microns in size solid particles. KOSUN Desander role is to reduce the load in addition to the mud downstream. In addition to the front mud install KOSUN Desander can effectively remove KOSUN desilter large number of particles in the load and improve efficiency Desilter. When the high-speed drilling, especially in the loose soil shallow well section, typically using a large diameter drill bit, it will produce a lot of drill cuttings, which may lead to the occurrence of port Desilter "rope" emissions, requiring in Desilter installed upstream of desander, where it can provide greater separation of the cliometric capacity for coarse cuttings. Only KOSUN Desander cleared the high concentration of large particles in the fluid cuttings, desilter can more effectively deal with the overflow Desanding on. If the penetration rate is slow, can only produce about half an hour tons of drill cuttings, in addition to drilling mud is usually able to handle all of the cycle, then can turn off KOSUN Desander.

Desilter to handle all non-drilling applications desilter for processing is necessary. However, in the viscous oil-based drilling fluids , at the bottom of a large number of adhesion effluent oil phase, so we can not make the heavier water-based drilling fluid, and can not handle heavier drilling fluid, because it will clear out of which a large number of barite. Desilter separation with all non-aggravated.

When the drilling fluid contains a lot of barite, processing separation, Oilfield Mud Tank Manufacturers and desilter (including mini-cyclone) can be used not only with other solids control equipment for processing. Since sand and Oilfield Mud Tank Manufacturers have approximately the same size class. Most barite particles 2 ~ 44m, a small amount of 44 ~ 74m, while only 8% to 15% between 0 ~ 2m. Separating at the level of granularity of KOSUN...