Vertical Cuttings Dryer Is Good Sieve Sieve Dried

Cuttings dryers is suitable for oil-based drilling fluids, DWM Solids control can be used。Drill cuttings to reduce the liquid content to reach the standard direct emissions.VERTI-G dryer shaker performance is relatively mature, the mass fraction of crude oil cuttings directly discharged after treatment up to 2%.

To 4%, 85% of total emissions, after the treated liquid centrifuge processed by the next level, the discharge of cuttings oil mass fraction of 15%, 15% of the total emissions, DWM Solids control is an integrated oil quality cuttings fraction up to 48%. Good sieve sieve dried.

vertical cuttings dryer using upper feeding mode, built-in high-speed centrifugal drum, the maximum amount of processing up to 40 t / h, the recovery of cleaning fluids can be reused,vertical centrifuge has been successfully applied in more than 200 wells around the world.

Hi-G Dryer applies to both oil-based and water-based drilling fluids

Wells were dried and may increase or decrease the number of shale shaker screens is based on usage.

Points, drying shaker effect can be achieved straight peace elliptical trajectory two kinds of vibration can be in a state of non-stop through the control box buttons to adjust the trajectory of debris after the mass fraction of crude oil-based drilling fluid dried sieve can be reduced by 50 % ~ 60%. Due to the high DWM solids control content of drilling dry sieve liquid recovery tank, you need to go through two centrifuges purification, oil content of cuttings treated up to 25%, the drilling fluid can be recycled again.

http://www.kosun.com/products/drilling-waste-management/

http://shale-shakers.com/drilling-waste-management/vertical-centrifuge.html