Ways to Reduce the Wear Degree of the Concrete Mixing Device

In order to ensure the mixer device production to reduce the degree of wear of, we are very familiar with and understand the whole mixer equipment lubrication parts skip type batching plant, below Hengyuan professional mixer equipment design engineer detailed explain. First of all is the mixer reducer gear and bearing is the use of gear oil splashing into the inner wall of the tank Concrete Brick Making Machine, into the bearing lubrication. The gear box of the oil surface should be appropriate in the two line between the oil dipstick. Too high or too low oil level will lead to the increase of temperature or bad lubrication, increase the power loss and cause the machine to work. The new machine to the first 150 hours and 300 hours respectively to replace the oil once, in order to eliminate the test did not completely clean the dirt. When working, should always check the oil level JS series double shaft concrete mixer, lack of timely replenishment. Then is the need to adjust the position where the exposed and rotational position should be kept with lubricating oil. But the brake band positions may not defile oil and water, so as not to affect the braking effect. The last is lubrication mixer motor motor in accordance with instructions. Above is Hengyuan manufacturers instructions of the mixer body need lubricating system, hope our customers at the time of production in accordance with the requirements of lubrication to the system, so as to ensure production life of mixer equipment is relatively long and production quality is guaranteed.