Submitted by: Submitted by bystritskiyv
Views: 300
Words: 565
Pages: 3
Category: Business and Industry
Date Submitted: 07/26/2011 12:11 AM
INSTALLATION INSTRUCTIONS FOR PART 95-7425
Nissan Rogue 2008 95-7425
KIT FEATURES
• Double DIN Radio Provision • Stacked ISO Mount Units Provision
APPLICATIONS
KIT COMPONENTS
A) Double DIN Radio Housing • B) Double DIN Brackets
A
B
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool • Phillips Screwdriver
1-800-221-0932
www.metraonline.com
© COPYRIGHT 2008 METRA ELECTRONICS CORPORATION
95-7425
T ABLE OF CONTENTS Dash Disassembly - Nissan Rogue 2008 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1,2 Kit Assembly - Double DIN/ Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . 3 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
*Note: Refer also to the instructions included with the aftermarket radio.
95-7425 DASH DISASSEMBL Y
NISSAN Rogue 2008
A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 If equipped with center speaker: Unclip and remove the grille (Figure A). Remove (4) Phillips screws securing the speaker. Unplug and remove the speaker. (Figure B). Unclip the panel above the radio including the a/c vents, then unplug hazard switch and remove. (Figure C) Note: If not equipped with center speaker skip step number 2. Continued on page 2.
B
C
1
95-7425 DASH DISASSEMBL Y
NISSAN Rogue 2008
D 3 Unclip the panel below the radio including the climate controls. Unplug climate controls and remove the panel. (Figure D) 4 Remove (4) Phillips screws securing the radio, unplug and remove radio. (Figure E) Continue to kit assembly.
A/C
PASS AIR BAG
E
2
95-7425 KIT ASSEMBL Y
DOUBLE DIN/STACKED ISO MOUNT UNITS PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
1 Snap the Double DIN brackets to the inside edge of the Double DIN radio housing. (Figure A) 2 Slide the Double DIN or the stacked ISO mount unit(s) into the...