Operating Procedures of Sand Production Equipment

Sand production line equipment has been more widely used in many industries. The first work is to prepare and to prevent the drill bits and other metal objects getting into the tertiary jaw crusher to avoid damage to the machine, because they will cause a blockage when material blocks and this has greater affect for normal production. After this process, you should immediately notify the next post operator is promptly removed to prevent access to the second-stage crushing system and cause the paralysis of the entire sand production line equipment system. And based on the size of the feed block and the crusher operation, users need to adjust the revolutions of the feeder belt to change the volume of feed.

Typically, the accumulation of material in the crushing chamber height should be more than 2/3 of the height of the crushing chamber. The gob diameter is preferably not more than 50% -60% of the feed spout width than the highest production capacity.When the automatic tripping of electrical equipment begins, if unexplained, non-forcible consecutive starts. In mobile inspection , if it is found out that the machine does not sound normal to stop failure, treatment should immediately stop feeding and discharge all of the material in the cavity to be broken, then the main motor should be stopped, finally check processing cut off the power. Attention to the control cabinet ammeter should be paid to start the main motor. After the start of 30-40s peak ,the current will be reduced to the normal operating current value. In normal operation, the current should also be paid attention to reach a longer time than the defined specified value. Operating in accordance with the procedures and fixing equipment properly, many operation problems can be completely avoidable.

gyratory cone crusher : http://www.ore-mills.com/crusher/45.htm

preheater : http://www.best-crushers.com/preheater.html

agitation vat : http://www.best-crushers.com/mine-mixing-bucket.html