Submitted by: Submitted by jcdawg37
Views: 1114
Words: 920
Pages: 4
Category: Other Topics
Date Submitted: 04/24/2013 10:52 PM
How Much Gas is Produced?
10/18/2011
Introduction:
The goal of this experiment was to measure the amount of gas produced in various reactions. The Ideal Gas Law was needed in order to calculate the mass of reactants and moles of gas produced: PV=nRT, where P is the pressure in atm, V is the volume in Liters, n is the number of moles, R is the ideal gas constant [0.082 (L∙atm)/(K∙mol)], and T is the temperature in Kelvins. Considering the units on R, it was important to convert pressure, volume, and temperature to atm, L, and K, respectively.
In this investigation, the volume of reaction space needed to be measured. One way to measure the volume was to use a string to measure the diameter and the length of the tube. The volume of reaction space =V=πr2h, where r is the radius of the tube and h is the length of the tube. Another important formula is the percent yield formula: % Yield=Actual Yield of GasTheoetical Yield of Gas×100
Materials & Procedure:
To begin the lab, all of the required materials were collected: HCL, CaCO3, tissue paper, string, a ruler, graduated cylinder, thermometer, two flasks, two beakers, a pipet, and a pressure measuring device. The mass of CaCO3 needed was calculated using the ideal gas law and stoichiometry; the amount needed was 0.256 g of CaCO3. Three measurements of 0.256 g were used for three trials. Each trial, CaCO3 was placed into a tissue paper, and then tied off with a string to prevent the loss of CaCO3. The diameter and the length of the tube connecting the pressure measuring device to the stopper were measured with a string and a ruler, and its volume was calculated using the simple equation for a volume of cylinder. After obtaining the volume, temperature of the reaction was measured using enough CaCO3 and HCL. 100mL of HCL was put into the flask. The tissue paper container was placed into the flask of HCL like a bag of tea and the stopper was quickly placed over the flask to prevent any pressure loss. Using...