Submitted by: Submitted by vipeakcompany
Views: 70
Words: 328
Pages: 2
Category: Business and Industry
Date Submitted: 03/11/2014 12:42 AM
Ball is now yields a larger grinding equipment , more extensive range of applications , mill works , while not complex, but there will be some of the intractable problems in the course of its operation , the need for technical staff to have more solutions Here we take a look at one of them, when the work should be ball bearing motor temperature exceeded how to deal with ?
grinding mill: http://www.raymondgrindingmill.org/Grinding_mill.asp
raymond mill: http://www.raymondgrindingmill.org/Raymond_mill.asp
ball mill: http://www.raymondgrindingmill.org/Ball_Mill.asp
When the ball mill and motor bearing temperature exceeds the specified criteria. You can try to touch his hand bearing a partial or total temperature is too high , then you can check the following aspects to deal with this situation the mill .
( 1 ) Check the various parts of the mill lubrication points , oil grades used are consistent with equipment factory manual .
( 2) Check whether the deterioration mill lubricants and greases .
If ( 3 ) Check the mill lubrication piping blockage or no direct access to the oil lubrication points , fuel shortage caused by fever.
Side of the gap ( 4 ) is too small ball bearing , the shaft bearing clearance is too large, too many contact points , can not form a uniform film on the pad .
( 5 ) ball bearing grease too much or too little, too agitated to form rolling grease generates heat , and the heat is not easy to shed . Too few poor lubrication , should be required to add a little oil , usually bearing gap is 1/3 to 1/2 more appropriate .
Hollow shaft sealing device ( 6 ) ball mill or both ends of the tight seal iron in direct contact with the shaft . The above problems , their reasons for processing , with the exception of the side bearing gap is too small , or the bottom of the contact angle too , must be grinding cylinder hydraulic jacking up the bush withdrawn from the side of the shaft, otherwise scraping watts mouth .