Different Methods of Feeding in Sand Production Line

In the production process, sand production line , the rational use of appropriate feeding method can effectively improve the performance and efficiency sand making production line . Fote sand production line , there are two main methods of feeding , will explain in detail below .Sand production line feeding method as the main center of the ring solitude falling waterfall feeding mode and feeding centers in two ways .The first way is when the material falls under the hopper , with the annular hole falls named . Below the bulk hopper tray directly into two shares , one share is falling from the surrounding bulk tray below ; while the other shares directly from the sub-feed tray directly into the impeller , after entering the impeller, quickly thrown in , Finally discharged from the feed opening .The second approach , the material first enters the hopper directly into the high-speed rotation of the rotor fully thrown, and part of the material after the first bounce percussive free fall , and then went to the impact on the surrounding vortex cavity back pieces, crackers rebound to the top of the crushing chamber , the latter deflected downward movement , and finally also in the ingredients discharge port .Many Sand are based feed in this way , but the new Sand nesting Another way is using a new way of feeding - feeding mode and overflow waterfall falling way into the material . First, the rotation speed of the overflow mainly use impeller whirl crushing chamber crushing , the purpose is to ensure that the intensity of the size of the material , when the impeller flow reaches the maximum load , it will be crushed by the crushing chamber . The waterfall fall- feeding , is composed of two feed inlet feed , mainly to avoid the particle size is larger than the impeller granular materials , vortex impeller and leaves work at the same time the work of Sand , forming a continuous sand production change the direction of the whereabouts of the material , thereby reducing the...