Adjustment and Running-in of Vibrating Screen Is Important

Circular Vibrating Screen earns this name by reason of its approximately circular movement. It is of multilayer and high efficient. The eccentric shaft vibration exciter and partial block help to adjust amplitude. This kind of screen is of long streamline, clear screening for different specifications. Adjustment and running-in of vibrating screen is very important.The adjustment and running-in of the vibrating screen:1.The vibrating screen spring must be vertical, the support of the spring and the contact surface of the spring should be horizontal, after the adjusting, we should use the bolt fasten the support of the spring to the sieve box trunnion, then weld them together.2.The driving direction of the vibrating screen is, when you stand in the feeding side, and face to the flow direction of the material, observe the location of the vibrating screen motor, you can have a right or left driving. When you should change the driving direction, unload the vibrating screen vibrator belt pulley from the balance wheel, reinstall it to the other side’s balance wheel and fasten it.3.Make sure the vibrating screen belt has enough slide adjustment, to ensure the groove of the two belt pulley can be one to one correspondence in their flat surface.4.After the installation and the adjusting, there will be at least 2 hours to running-in, so vibrating screen must operating reposeful, no abnormal noise, the swing and the the motion trail are match the requirment, the vibrating screen bearing’s highest temperature can not above 75 centigrade.5.If vibrating screen is eligible after the running-in, we can put it into running-in loading, the vibrating screen running-in loading time can be decided as to the process and startup requirement.6.We must turn the vibration exciter before running-in. if vibrating screen has no jammed phenomenon and it can turn flexibly, we can open the vibrating screen machine.high frequency screen:...