Solids Control Equipment of Mud Gun Role and Scope

KOSUN NJQ mud gun is designed to prevent mud tanks for sale and all corners of the pump suction Solid Control System precipitation, mainly used in high-pressure jet mud mixing tank for pulp, also be used to transport the mud between the warehouse.

At home and abroad are using drilling fluid circulation tank rectangular structure, because a good installation and transport properties of such a solids control system. Meanwhile, in this case, no matter how sophisticated the slurry agitator, a large amount of dead space inside the mud tank will occur. To solve this problem, install low-voltage abroad in large water tank with a nozzle mixing line, while the domestic is used mounted on the roof of mud gun (gun drilling) to agitate those dead.

Stirred slurry tank installed hydraulic lines, can not be eliminated with a mechanical stirrer with stirring to the dead zone, but due to a large number of vertical hydraulic stirred mud tank installed pipeline, may not only damage the stirrer due to the convection flow patterns, increasing the power of the stirrer, but also Magnetic Drive Agitator is very easy to clean up the sand. Therefore, the mud tank has not been installed due to internal circulation of such pipelines.

According to the study, mud gun effective role depth of only 1.5 ~ 2.7m, its size and fluid density, viscosity, and nozzle velocity. Mud gun use has some limitations. Mud gun is a mechanical stirrer aids, using only mud gun can not solve the problem of drilling suspended solid phase. Mounted on top of the tank activities need to be adjusted mud gun, some dead still hard to eliminate. Meanwhile the drilling fluid has been precipitated solid phase and then the mud spray gun is easy to block, blocking the nozzle cone drilling or damage caused by drilling pump. These shortcomings limit the use of mud gun.