Indicates to Remedy the Ball Mill Tile Oil Leakage Difficulty

Shanghai Zenith is a qualified ball

mill supplier, and it produces different ball mill solutions and analyzes the utilized ball

mill tUsed Mining Equipment Spare Partsroubles for its client. Shanghai Zenith will not be only a ball mill supplier in China,

but additionally the resolution scheme.

Following the ball mill operates for some time, you can find some spray orifice to the spray bar

and that is blocked by the impurities during the oil, at this time, the oil stress within the spray

orifice rises which leads for the other orifices unplugged increase in movement chart. The oil

close to the oil slinger will splash from the oil slinger which prospects for the oil leakage.

Solutions: dredge the blocked oil hole to the spray bar, and test the ball mill spray bar

on a regular basis and clean in time when the banked-up spearhead is identified. Pay out consideration to the

clean the oil sprout hole by the delicate texture device to prevent the hardness material damage

towards the oil sprout hole.

There's an additional motive for that ball mill oil leakage, which is when the opening from the ball

mill front (rear) tile accelerator is relatively huge, the oil sprout quantity will be

increased. So the oil will drop from the orifice on the hollow shaft then splash out of

the oil slinger and leak out from your felt oil seal.

And the ball mill resolution is always that turning down the accelerator appropriately to decrease the

sprout oil mass. When adjust the accelerator, it should be done by the knowledgeable persons.

As in situation the accelerator is turned down undersize, the lubricant oil amount of your

bearing shall be insufficient as well as friction force will likely be enhanced which makes the key

bearing set temperature rises. Once the phenomenon can be handled, the key bearing

will likely be burnt up.

As being a ball mill and jaw crusher

supplier in China,...