Mistakes Cause Low Efficiency for Traditional Dryer

The traditional dryer has low yield and is of high cost, this is a huge loss of heat and the quality of the finished product is too poor for a lot of error. In order to limit the speed flow of the material to the export direction, only the drum speed limit is very low so that the rollers can be inside the material, its number of amount is greatly reduced. Therefore resulted in the greatly reducing of the number in dynamic contact materials and hot air.

Host into the fire-side high and low end of a distant fire tilt was installed and again reduced, so that the amount of material will stay in the drum storage. this method of installation can only speed up the rate flow of the material to the distant fire end, but the entire drum front after thousands publicity material board is at the same time lifting. The melodies of material will be little. Drum space utilization is very low, losing a large amount of heat energy white. This design gave the device installation, and operation of the dryer machine or rotary dryer causes unnecessary obstacles.

Because of the tilt angle of the host installation must specifically fit with a non-slip prop round to secure the equipment to prevent the decline in the running, it is very troublesome. Drum wind speed is too low, resulting in relaxation dynamic and static contact with the intensity of the material and hot air, resulting in inefficient equipment drying. Diameter is too wide, but can not take full advantage of the machine and has resulted in heat loss. Drum materials will be soon pumped Results are that drum material storage capacity is too low, it reduced dynamic and static contact area of the material and hot air. Enterprises should avoid these misconceptions and research new equipment to meet demands.

conveyor belt : http://www.best-crushers.com/conveyor-belt.html

dust collector : http://www.ore-mills.com/dust-collector.html

cone breaker : http://www.hxjq-crushers.com/news_144.htm