Can You Tell Me Some Different Kinds of Ball Mills?

Different kinds of ball mill it inspection standard are all different, the cement mill inspection standard what? Below we focus on the once, cement mill inspection standard. Ceramic ball mill is mainly designed to mix, and mill materials. With less energy, it produce high fineness product. It has two types, wet mills and dry mills. According to product requirement to satisfy different customer’s requirement, the machine could use different lining board products. The milling fineness depends on the milling time. The motor is started by the coupling which can reduce voltage and lower the starting electricity. The structure is divided into integral type and freestanding type.1. Watts a spherical surface evenly have horns; Every 50 x7 was not less than 50 in 1, 2 point; Hollow shaft and tile interface should be 90 °, 100 ° every square inch of not less than 2 points, shaft neck and bearing clearance approximate the same on both sides.2. Cement mill when installation should be lining board first to be installed by cover, cylinder liner should start with population, according to the assembly requirements, the screws to even the tight, shall not be leaking. Rubber lining board with may not have crack, there are gaps in relation to sponge.3. Cement mill barrel flange to the front of the face should ensure that cover with good contacts, not add gaskets, two hollow shaft don"t allow the coaxial tolerance of less than 0.8 mm difference. Big tooth circle and the cylinder cover in connection assembly correction, should be strong thrust, superior location pins, the circle of radial run-out not more than 0.5 mm, axial runout not greater than 0.84 mm.The ball mill is a key equipment to grind the crushed materials, and the ball mill is widely used in powder-making production line including cement, silicate, new-type building material, refractory material, fertilizer, ore dressing of ferrous metal and non-ferrous metal, glass ceramics, etc, and the ball mill can grind various ores...