Matters in Installation of Ball Mill Is Have Numerous Types Rod Hammer and Gfrinding Mill Bearing

Ball mill is have lots of forms rod hammer and gfrinding mill bearing plate of the longitudinal center line of your coaxial error is not greater than 1mm, the transverse center line of parallelism error no more than 0.5mm / m.key bearing bottom plate processing surface should be situated in the same horizontal plane, the installation is accessible when liquid with each other using the device or level, level measurement, the longitudinal and transverse horizontal deviation not higher than 0.1mm / m, two floor relative height difference is less than 0.5mm, plus the feed end higher than the discharge end.

Ball mill is have quite a few types rod hammer and gfrinding mill bearing on the spindle bearing base plate, to ensure that the two center line, the bearing and also the bearing seat speak to surface along their sides needs to be uniform contact, regional clearance shall not be higher than 0.1mm, will not contact the edge length shall not exceed 100mm, the cumulative length of no greater than about 1 / 4 of length, otherwise, must be treated.

The key bearing assembly accessories to locate a positive impact, may be removed temporarily, to locate it, as outlined by the installation need to have timely installation of ball mill is have lots of kinds rod hammer and gfrinding mill. Bearing installation on bearing stress testing, its value should really not be much less than 25Mpa, trial of continuous period of not significantly less than 10min, for example the discovery of the complete elimination of leakage needs to be.

The upper cover is installed before, should be 1st ball mill is have quite a few kinds rod hammer and gfrinding mill major bearing cooling water pipe on the water test, test pressure is 0.45 ~ 0.6Mpa, 30min test time, there really should be no leakage phenomenon.

Spiral classifier price line height: 15pt" align="left">Ball mill is have numerous types rod hammer and gfrinding mill bearing seat is installed, should really verify the bearing seat of...