Encoder System Analysis

ENCODER

Documentation

A0001229 Rev 1.3, Aug 2011

101 0100101010100000010101010100010101010010101000100010101011111110010100001010100100101010001010101010100101010101001010

0001010101001010100010001010101111111001010000010010100101010010101010000001010101010001010101001010100100100101010010010010

IMPIKA - 135 rue du Dirigeable - 13400 Aubagne - France

Tel : + 33 (0)4 42 62 43 00 Fax : + 33 (0)4 42 62 42 99 www.impika.com

IMPIKA assumes no responsibility for any errors that may appear in this document. If you have any suggestion for improvements or amendments or have found errors in this publication, please notify us. At the time of publication, this document is intended to be as comprehensive and accurate as possible. However, information contained hereafter can be subjected to modification without prior notice. IMPIKA reserves the rights to modify the features and ESifications of its products without prior notice. This document has been designed by IMPIKA for its customers but also for its internal use. The information contained hereafter is the property of IMPIKA and cannot, under any circumstances, be totally or partially reproduced in any form or by any means including photocopying, without express written permission of IMPIKA. When devices are used for applications with technical safety requirements, the relevant instructions must be followed. Failure to use IMPIKA software or approved software with our hardware products may result in injury, harm, or improper operating results. Failure to observe this information can result in injury or equipment damage. Copyright © 2010 IMPIKA. All rights reserved.

A0001229 – Encoder Documentation

Table of Contents

1 2 3 About this Guide..........................................................................................4 introduction..................................................................................................5...