Mud Agitator Increasing the Stirring Effect

Mud agitator can generate vortex motion, thus increasing the stirring effect. Clamp the blade in the middle of the tray can be prevented after the shutdown slurry of solid particles deposited on the periphery of the lower blade, so that when starting to use the precipitate can reduce the resistance moment of the blade, thus avoiding the motor starter overload and burn.

http://www.decantingcentrifuge.com/products/solid-control-equipment/jet-mud-mixer.html

Mud agitator by a group of cyclone shaker and a breakdown of the composition of the upper part of the cyclone, the lower part of the shaker. 100mm from the group consisting of a cyclone swirler. Mainly used to deal with increased drilling, recycling barite; heavier drilling fluids can also be used for non-recovery of precious liquid. While the slurry process is merely a stirrer cyclone underflow material, not all the drilling fluid flow, the cleaner will shaker occurrence of clogging tendency, the following approach may be used to prevent and overcome.

http://www.solid-control-system.com/

For active mud system compartments less than 5 feet high (1.52 meter), as it is not much deep, flat impeller should be used to generate radial flow in the drilling fluids. if the impeller are properly located, it would produce axial flow on the mud flow in the compartment and suspension will be adequate for most application.

If the mud tank is higher than 5 feet, an 60° angle canted impeller would be used to produce radial flow & axial flow. If the tank is higher than 12 feet (3.66 meters), two or more impellers would be used in combination on the shaft.

Mud Agitator combines compact design with high torque performance levels necessary for a uniformly suspended flow of drilled solids throughout the mud systems.

KOSUN MA series mud agitator is part of the drilling fluid solids control equipment, which is mainly used to agitate and mix the drilling mud to prevent solids particles from depositing in the circulating...