Networking

(Image Showing BGP set up)

` The BGP set up consists of three routers, on router one the host name is R1 and its serial port is 0/0, it was then giving the IP address 10.10.10.1 and a subnet mask of 255.255.255.0, the clock rate was manually set at 64000 bits, the loopback was then configured, loopback 0 was giving an IP address of 100.100.100.1 and a subnet of 255.255.255.0 and the second loopback1 was giving an ip of 101.101.101.1 and subnet of 255.255.255.1. BGP was then configured on router 1and it was given an AS number of 100, a router id of 1.1.1.1.

On router two, the host name was R2 on serial port is 0/0; it was given the IP address of 10.10.10.2 and as subnet of 255.255.255.0. On serial port 0/1, it was given an IP address of 20.20.20.1 and a subnet of 255.255.255.0 and a clock rate of 64000 bits. BGP was then configured on router 2 and it was given an AS number of 200, a router id of 2.2.2.2.

On router 3, the host name was R3 on serial port 0/1 it was given an IP address of 20.20.20.2 and a subnet of 255.255.255.0. BGP was then configured on router 2 and it was given an AS number of 300, a router id of 3.3.3.3.

(Image showing EIGRP set up)

(Image showing Pc2 pining Pc1)

The EIGRP set up consists of two routers, two switches and two end devices, serial port 0/3/1 was given IP address of 12.12.12.1 and a subnet of 255.255.255.0 and the clock rate was manually set to 64000. The fast Ethernet port was given an IP address of 1.1.1.1 and subnet mask of 255.255.255.0. EIGRP was then configured on router 1 with an AS 10, then the networks that are going to be receiving messages which were 1.1.1.0 and 12.12.12.0

Router 2 with serial port 0/3/1 was given an IP address of 11.11.11.1 and subnet mask of 255.255.255.0, the fast Ethernet port (fa0/0) was given an IP address of 2.2.2.1 and a subnet mask of 255.255.255.0. The EIGRP configuration with AS 10, the networks that are going to be receiving messages which were 2.2.2.0, 11.11.11.0 and 12.12.12.0.