The Three Upkeep Points of Pulverizer

Initially, screen repair and replacement. Screen is created of thin steel plate or metal punching.

Once the screen seems the breakdown put on or foreign bodies, in the event the damaged location is compact,

could make riveting or soldering for remediation; if extensive harm, replace the new screen.

Installation screen should really be made towards the sieve using the burr side, the smooth

outwards, the screen surface and screen frame to fit tightly. Sieve sieve ring when

installed, the lap along the inner layer of stubble ought to be the direction of rotation to

stop the material stuck inside the lap.

Second, the bearing lubrication and replacement. soon after every single 300 hours of operate

should be cleaned bearings. If the bearings are oil lubricated, add new oil to fill the

housing gap when 1 3 is suitable, no over 1 two, just before the job is usually a

small cap sort oil can tighten the lid. Once the mill bearings badly worn or damaged really should

be replaced, and spend attention to strengthening lubrication; use of tapered roller bearings,

axial bearings must be cautious to check the interval to keep it as 0.two 0.four mm, if not, can

boost or decrease Office paper pads bearing cap to adjust.

Third, claw and hammer tooth replacement. Parts of crushing, grinding teeth and claw

hammer would be the wearing parts in the feed

, but additionally have an effect on the high-quality and

productivity of crushing principal components, grinding teeth and claws worn hammer should really be

promptly replaced. Replacement teeth tooth claw crusher claw, the first disc to be pulled

out. Pull out just before it gets round the back of open disc lock nut pieces, with all the hook

beneath the round nut wrench, and after that devoted the disc out lesbian. To ensure balanced

operation of the rotor, for complete sets of replacement teeth need to spend focus, for

soon after the static balance test should...